Common faults and troubleshooting of the hottest p

2022-08-02
  • Detail

Common faults and troubleshooting of the baling machine

condition 1:

tape clamping treatment. When the tape is stuck in the middle of the weak and stable market price of imported ore on the 18th of the roller, or there are foreign objects blocked and cannot be removed, the treatment methods are as follows:

a. remove the washer of the hexagon nut

b. loosen the two M5 countersunk screws on the intermediate connecting shaft. Since these two screws are fixed on the notch of the connecting shaft, the screws must be turned up

c. remove the connecting shaft, pick up the upper turbine and take out the stuck objects

d. assemble and restore according to the above c-b-a method

e. pay attention to keep the nut and L-shaped curved plate 0 5mm gap

condition 2:

the semi-automatic packer does not automatically take out the belt. In this case, first check whether the length of the belt is adjusted at 0, and then check whether the process of threading the belt is correct. If not, foreign matters are stuck near the belt feeding roller, which will also cause this situation

condition 3:

the belt will not be cut after binding, which can be caused by many conditions

a. the tightness adjustment is too tight

b. there is oil on the slip sheet or slip belt, which are all located near the tightness adjustment and must be removed to wipe off the oil

c. if the belt is too tight, lower the belt drive seat or adjust the motor back

d. use a thinner belt or the clearance of the unwinding roller is too large

condition 4:

poor bonding effect

a. the temperature is too high or not enough. Sometimes, special belts have poor viscosity, and the temperature must be very accurate

b. the voltage used is not enough. The voltage of many factories is often insufficient. If the extension cable or cable is used again, the voltage drop will be caused, which will lower the original adjusted temperature, or even burn out when the motor is tied tightly. Therefore, try to avoid using the cable. If the extension cable must be used, it must be connected with a thick wire with advanced steel materials that is not too long

c. the 635 bearing under the middle knife is broken, so it is heated and cannot be bonded

d. the long pull spring on the electric strange hand (swing rod) is tired, so the strange hand cannot be pulled to the position, resulting in half or less bonding

e. the electric heating steel sheet is too high and too low, or left and right, so it encounters the upper and lower PP strips, or the left and right cutting tools, and cannot enter the heating. It must be adjusted according to the situation

f. the temperature is too high due to the fault of the air fan for smoke exhaust

condition 5:

no action during tape insertion

the LS1 micro switch on the right side of the upper sliding plate is faulty or the shrapnel is blocked by foreign matters and cannot touch the contact

condition 6:

continuous lignin/polyurethane (PU) operation

a, ls5 fault

b, LS1 is not fault, but there is dirt stuck between the contact and the shrapnel, or the shrapnel itself is stuck, so that the contact cannot be released after inserting the tape as usual

c, when ls5 is reset to zero, the contact is not closed, so the power supply will work continuously as soon as it is turned on

condition 7:

cut off before binding

a. adjust the machine tightness. If the parting surface and gate are too loose, tighten them

b, LS3 and ls5 are improperly positioned

c. demagnetization induction switch failure

Copyright © 2011 JIN SHI