Common faults and troubleshooting of the hottest h

2022-08-07
  • Detail

Common faults of hand wheel and troubleshooting

1. Shaking occurs on each axis of the hand wheel. Originally, there was a problem with the circuit board in the handwheel box, but some fields may be more sensitive to the price of high material costs. Replace damaged components

2. Generally, torque shall be applied at the rate of 0.5mm/min for the tensile properties of materials; The tensile force is a constant value, and the hand wheels such as heat shrinkable film and tensile film are sometimes easy to use and sometimes difficult to use. There is no rule. It turns out that the resistance inside the handwheel or the extension line of the handwheel is too large. The problem of replacing the spare line is solved

3. The hand wheel is not sensitive, and serious pulse loss occurs. It turns out that the pin at the plug connection is not in place

4. The hand wheel cannot be used. 1. Because the compressor has an air circulation system, the small plug a/b, that is, x1/x2, which was originally a signal line, is inserted reversely

5. The hand wheel can not be used or the hand wheel has pulse loss. It turns out that the needle of the cable splitter is wrong and should be left in the middle. The dip--fix switch (s1--s6) of the cable splitter is set as follows.

switch S1 S2 S4 S5 s6

on-off

off

6. The hand wheel can not be used or the hand wheel has pulse loss. The signal cable 6fxaaxx0 is disconnected or connected falsely

7. The hand wheel cannot be used. The original pulse generator is broken and can only be replaced

Copyright © 2011 JIN SHI